DOCUMENT:Q71135  06-DEC-1999  [win95x]
TITLE   :DCA Irmatrak Network Card and Windows 3.0
PRODUCT :Microsoft Windows 95.x Retail Product
PROD/VER:WINDOWS:3.0,3.0a
OPER/SYS:
KEYWORDS:

======================================================================
-------------------------------------------------------------------------------
The information in this article applies to:

 - Microsoft Windows versions 3.0, 3.0a 
-------------------------------------------------------------------------------

SYMPTOMS
========

If you run Microsoft Windows version 3.0 in enhanced mode on a Novell network
with a DCA Irmatrak Token ring board, you may not be able to see files on a
network drive within File Manager, and the print servers may not show up when
you select the network printers in Control Panel.

This information applies to Microsoft Windows version 3.0, and 3.0a. This
information does not apply to later versions of Windows.

CAUSE
=====

This is a known problem with the DCA Network drivers supplied with the card.

WORKAROUND
==========

There are two methods you can use to work around these problems:

 - Run Windows in standard or real mode.

   -or-

 - Disable the DMA for the Network card.

   To disable the DMA, you need to run the JUMPERS utility. JUMPERS is a Novell
   shareware utility that allows you to change the IPX.COM without rerunning
   SHELLGEN. (SHELLGEN is a Novell utility for generating IPX.COM. It allows you
   to specify the type of network card and its configuration.) JUMPERS is
   located on the Installation and Configuration disk that comes with the DCA
   board. To run the JUMPERS utility, type "jumpers ipx.com" (without the
   quotation marks) from the MS-DOS prompt and then select none for DMA.

MORE INFORMATION
================

To resolve the problem on a more permanent basis, you need to update your driver
files. Check if the following Novell files are earlier than version 3.02 or have
dates earlier than the following:

   IPX.OBJ             12/18/90
   NETx.COM            02/06/91
   VNETWARE.386        03/11/91
   NETWARE.DRV         04/01/91

These files can be downloaded via NETWIRE on COMPUSERV. To get them, type "GO
NOVLIB" and then download the WINUP2.ZIP file.

Version 1.10 is the minimum required to correct the problem. If you have version
1.10 or later, you do not need the updated Novell files above. You can obtain a
current version of the DCA network drivers from the DCA Update Department.

The products included here are manufactured by vendors independent of Microsoft;
we make no warranty, implied or otherwise, regarding these products' performance
or reliability.

Additional query words: 3.0 3.00 win30 3rdparty 3.00a

======================================================================
Keywords          :  
Technology        : kbWin3xSearch kbZNotKeyword3 kbWin300 kbWin300a
Version           : WINDOWS:3.0,3.0a

=============================================================================

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS
PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND.  MICROSOFT DISCLAIMS
ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.  IN NO
EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR
ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL,
CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF
MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES.  SOME STATES DO NOT ALLOW THE EXCLUSION
OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES
SO THE FOREGOING LIMITATION MAY NOT APPLY.

Copyright Microsoft Corporation 1999.